CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 46 of 128
Errors 1000-1999
1413 'The spindle positioning speed cannot be zero'
DETECTION During execution.
CAUSE The programmed positioning speed for function M19 is zero.
SOLUTION Program a positioning speed greater than zero using the syntax: "S.POS =".
1414 '#PARK: this instruction only admits one axis'
DETECTION During execution.
CAUSE The #PARK instruction can only park one axis.
SOLUTION Program a #PARK block for each axis to be parked.
1417 'File path too long'
DETECTION During execution.
CAUSE The maximum number of characters allowed for the path of a program or subroutine
has been exceeded.
The path of a program or subroutine may have a maximum of 120 characters.
SOLUTION Move the program or subroutine to another directory to reduce the number of
characters of the path.
1418 'An axis of the main plane or of the active transformation cannot be parked'
DETECTION During execution.
CAUSE An attempt has been made to park (#PARK) an axis that is part of the main work plane
or of the active kinematics.
SOLUTION Check the program.
1419 'An axis of a gantry axis or a coupling (slaving) cannot be parked'
DETECTION During execution.
CAUSE An attempt has been made to park (#PARK) an axis that is part of a gantry axis or
of an active coupling (#LINK).
SOLUTION Check the program.
1420 'Open control blocks at the end of the program'
DETECTION During execution.
CAUSE Some "$" control block does not have its corresponding closing instruction.
SOLUTION Check all the "$" control blocks of the program and subroutines: $IF - $ENDIF, $FOR
- $ENFOR, $SWITCH - $ENDSWITCH, …
1421 'The axes of the active transformation can neither be slaves nor parked'
DETECTION During execution.
CAUSE One of the axes involved in the programmed transformation is parked, is a slave of
a gantry pair or is a slave of an active coupling.
SOLUTION Unpark, deactivate the active coupling or undo the gantry pair in order to use the axis
in the transformation.
1422 '#CS ON/#ACS ON: wrong programmed mode'
DETECTION During execution.
CAUSE The programmed MODE parameter is wrong.
SOLUTION The value of the MODE parameter must be between 1 and 6.
1423 '#CS ON/#ACS ON: the parameter of an aligned axis must be 0 or 1'
DETECTION During execution.
CAUSE The value programmed for the parameter of an aligned axis is wrong.
SOLUTION The value of the parameter of an aligned axis must be 0 or 1.
1424 'G function not allowed while MCS is active'
DETECTION During execution.
CAUSE The programmed G function cannot be executed while #MCS is active.
SOLUTION Check the program.
To Next Page
Loading...
