CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 50 of 128
Errors 1000-1999
1453 'Axis name too long'
DETECTION During execution.
CAUSE The axis name has more than two characters.
SOLUTION The valid axis names are:
X, X1 … X9, Y, Y1, … Y9, …, Z, Z1, … Z9
A, A1 … A9, B, B1, … B9, …, C, C1, … C9
U, U1 … U9, V, V1, … V9, …, W, W1, … W9
S, S1 … S9
1455 'PROFILE: Null profile'
DETECTION During execution.
CAUSE The possible causes are:
• In the profile cycle of the cycle editor, the file containing the profile cycle is missing.
• The file indicated in the profile cycle of the cycle editor is empty.
SOLUTION The profile cycle of the cycle editor must indicate the file containing the profile.
1456 '#POLY: Parameters missing'
DETECTION During execution.
CAUSE When programming the #POLY instruction, some mandatory parameter "EP" or "SP"
is missing
SOLUTION Check the syntax of the instruction in the programming manual.
1457 '#POLY: parameter value'
DETECTION During execution.
CAUSE The possible causes are:
• The interpolation parameters of the polynomial are wrong.
• The curvature radius is less than or equal to zero.
SOLUTION The interpolation parameters of the polynomial must be positive, SP < EP and the
curvature radius must be greater than zero.
1458 '#POLY: Too many axes have been programmed'
DETECTION During execution.
CAUSE More than three axes have been programmed in the polynomial.
SOLUTION A polynomial interpolation can only be programmed for three axes.
1459 '#POLY: Wrong starting point'
DETECTION During execution.
CAUSE The starting point of the polynomial is not the same as the current position.
SOLUTION Modify the independent term of the polynomial for each axis make it the same as the
end position of the previous block.
1461 'G9: The arc's intermediate point has been programmed wrong'
DETECTION During execution.
CAUSE One or both coordinates of the arc's intermediate point have not been programmed.
SOLUTION Function G9 requires the programming of both coordinates of the arc's intermediate
point.
1462 'G8: the tangent path cannot be calculated'
DETECTION During execution.
CAUSE An arc tangent to the previous path cannot be done with the programmed radius and
end point.
SOLUTION Check the values of the programmed radius and end point.
1463 'G9: Circular path programmed wrong'
DETECTION During execution.
CAUSE No arc can go through those three points.
SOLUTION Define two points in the block that define an arc with the end point of the previous
movement. Bear in mind that all three points must be different and cannot be in line.
To Next Page
Loading...
