CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 55 of 128
Errors 1000-1999
1503 'The variable requires programming an axis'
DETECTION During execution.
CAUSE An axis variable has been programmed, but no axis has been indicated for which to
read or write a variable.
SOLUTION Refer to the programming manual for control variables.
1504 'The variable does not allow programming an array index'
DETECTION During execution.
CAUSE An array index has been programmed when reading or writing a variable that is not
an array variable.
SOLUTION Refer to the programming manual for control variables.
1505 'The variable does not allow programming an axis'
DETECTION During execution.
CAUSE An axis has been programmed when reading or writing a variable that is not an axis
variable.
SOLUTION Refer to the programming manual for control variables.
1506 'Undefined label or #RPT command labels swapped'
DETECTION During execution.
CAUSE The possible causes are:
• The second label has not been defined.
• M30 has been programmed between the first and the second labels.
• In the #RPT instruction, the second label has been programmed first and then
the first one.
SOLUTION Define the labels and the instruction correctly.
1507 'The second label of the #RPT must be programmed alone in the block'
DETECTION During execution.
CAUSE When programming the #RPT[N1,N2] instruction, the second label must be
programmed alone in the block without any other type of command. This error would
come up if N2 :X10 were programmed.
SOLUTION The last label must be programmed alone in the block. Program the command in the
previous line to execute it with #RPT or in the next line not to execute it with the #RPT.
1508 'G201 and active C axis are not allowed on the axes of the main plane'
DETECTION During execution.
CAUSE The possible causes are:
1. G201 has been programmed for a C axis that is also one of the first three axes
of the channel.
2. One of the axes programmed in the #FACE instruction is in additive manual mode,
G201.
SOLUTION The possible solutions are:
1. Program #FACE OFF so the axis stops being a C axis.
2. Program G202 #AXIS [axis] so the axis stops being in additive manual mode.
1509 '#SET AX/#CALL AX: Offset programming has no effect'
DETECTION During execution.
CAUSE All the axes programmed in the instruction already belonged to the current
configuration and, therefore, the instruction only means a change of order
(sequence). In this case, the programmed offset option has no effect.
SOLUTION Check the program.
To Next Page
Loading...
