CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 14 of 128
Errors 1000-1999
1050 'Considering the tool offsets, it exceeds the data range'
DETECTION During execution.
CAUSE The tool dimensions exceed the maximum values.
SOLUTION Modify the tool dimensions.
1052 'Values resulting from the measurement out of range'
DETECTION During execution.
CAUSE When taking a measurement with function G100, the obtained value is too large either
for the coordinate where it probed, either for the offset obtained in that probing move.
SOLUTION The value obtained in that probing move must be between (-2147483647,
2147483646)
1054 'Nonexistent fixture'
DETECTION During execution.
CAUSE The programmed fixture index is wrong.
SOLUTION The value of the fixture index must be more than zero and less than ten.
1055 'D and the tool radius cannot be modified in the same block'
DETECTION During execution.
CAUSE An attempt has been made to write the "V.G.TOR" variable in the same block where
a tool change or tool offset change is programmed.
SOLUTION Programming in different lines.
1056 'Too many external variables'
DETECTION During execution.
CAUSE The maximum number of external variables (500) supported by the CNC has been
reached.
SOLUTION Check the program.
1057 'Variable without reading permission'
DETECTION During execution.
CAUSE An attempt has been made from part-program or MDI to read a variable without
reading permission via program.
SOLUTION The variable cannot be read from a part-program or MDI. The programming manual
indicates whether or not each variable has reading permission via program / MDI,
interface and PLC.
1059 'Variable without writing permission'
DETECTION During execution.
CAUSE The user has tried to write a variable without writing permission. An attempt has been
made from part-program or MDI to write a variable without writing permission via
program.
SOLUTION The variable cannot be written. The variable cannot be written from a part-program
or MDI.
The programming manual indicates whether or not each variable has writing
permission via program / MDI, interface and PLC.
1060 'N label value out of range'
DETECTION During execution.
CAUSE An "N" block number has been defined that is not within the permitted range.
SOLUTION The block number must be a positive value lower than 2147483646.
1061 'Nonexistent G function'
DETECTION During execution.
CAUSE The programmed G function does not exist.
SOLUTION Check the program.
1062 'Incompatible G functions'
DETECTION During execution.
CAUSE Two G functions incompatible with each other have been programmed in the same
block.
SOLUTION Program them in different blocks.
To Next Page
Loading...
