Fuji Xerox Color 550

7 Problem Solving
198
Problem Solving
7
012-211
012-212
012-213
012-214
012-215
012-216
012-217
012-218
012-219
012-247
012-223
012-221
012-236
012-235
012-237
012-238
012-239
012-240
012-255
012-260
012-282
012-291
[Cause] Finisher malfunction
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then
switch on the machine power. If the error still is not resolved, contact your local
Fuji Xerox representative.
012-225
023-226
012-227
012-229
012-230
012-241
012-243
012-246
012-265
[Cause] Booklet Maker malfunction
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then
switch on the machine power. If the error still is not resolved, contact your local
Fuji Xerox representative.
012-264
[Cause] The Booklet Maker is not fully inserted completely into the Finisher.
[Remedy] Completely insert the Booklet Maker into the Finisher, and turn the machine off
and then on.
012-250
012-251
012-252
012-253
[Cause] Folding Unit malfunction
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then
switch on the machine power. If the error still is not resolved, contact your local
Fuji Xerox representative.
012-911
[Cause] The sensor was activated because paper output to the finisher was removed before
the finisher tray lowered and completely stopped in position. Or, there is a foreign
object under the finisher tray.
[Remedy] If there is any foreign object under the finisher tray, remove it and then turn the
machine off and on. If the error persists, contact your local Fuji Xerox
representative.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact your local Fuji Xerox
representative. The contact number is printed on the label or card attached on the machine.