Fields in the Advanced Settings IP Options menu
Field Description
OSPF Mode Select whether and how routes are propagated via the interface
and/or OSPF protocol packets are to be sent.
Possible values:
• Passive (default value) OSPF is not activated for this inter-
face, i.e. no routes are propagated or OSPF protocol packets
sent over this interface. Networks reachable over this inter-
face are, however, included when calculating the routing in-
formation and propagated over active interfaces.
• Active: OSPF is activated for this interface, i.e. routes are
propagated or OSPF protocol packets sent over this interface.
• Down : OSPF is disabled for this interface.
Proxy ARP Mode Select whether your device is to answer APR requests from
your LAN on behalf of the specific PPTP partner.
Possible values:
• Inactive (default value): Disables Proxy-ARP (Address
Resolution Protocol) for this PPTP partner.
• Up or Dormant: Your device answers an APR request only
if the status of the connection to the PPTP partner is Active
or Idle. In the case of Dormant, your device only responds
to the ARP request; the connection is not set up until
someone actually wants to use the route.
• Active Only: Your device answers an APR request only if
the status of the connection to the PPTP partner is Active,
i.e. if a connection to the PPTP partner has already been es-
tablished.
DNS Negotiation Select whether your device should obtain IP addresses for
Primary DNS client, Secondary DNS client from the PPTP
partner or should send these to the PPTP partner.
The function is activated with Enabled.
The function is enabled by default.
Fields in the Advanced Settings PPTP Callback menu
Funkwerk Enterprise Communications GmbH
14 VPN
bintec W1002/W1002n/W2002/WIx040/WIx065 259
To Next Page
Loading...
Need help?
General
