agement -> Global Settings -> System Licenses -> New menu.
The System Management->Global Settings->System Licenses->New menu consists of
the following fields:
Fields in the System LicencesBasic Parameters menu
Field Value
Licence Serial Number Enter the licence serial number you received when you bought
the licence.
Licence Key Enter the licence key you received by e-mail.
Note
If Not OK is displayed as the status:
• Enter the licence data again.
• Check your hardware serial number.
If Not Supported is displayed as the status, you have entered a license for a sub-
system that your device does not support. This means you cannot use the functions of
this licence.
Deactivating a licence
Proceed as follows to deactivate a licence:
(1) Go to System Administration -> Global Settings -> System Licences.
(2) Press the icon in the line containing the licence you want to delete.
(3) Confirm with OK.
The licence is deactivated. You can reactivate your additional licence at any time by enter-
ing the valid licence key and licence serial number.
8.3 Interface Mode / Bridge Groups
In this menu, you define the operation mode for your device's interfaces.
Bridging
Bridging connects networks of the same type. Bridges operate at layer 2 of the OSI model
(data link layer), are independent of higher-level protocols and transmit data packets using
MAC addresses. Data transmission is transparent, which means the information contained
8 System management Funkwerk Enterprise Communications GmbH
96 bintec W1002/W1002n/W2002/WIx040/WIx065
To Next Page
Loading...
Need help?
General
