Chapter 7 Access and configuration
This chapter describes all the access and configuration options.
7.1 Access Options
The various access options are presented below. Select the procedure to suit your needs.
There are various ways you can access your device to configure it:
• Via your LAN
• Via the serial interface
7.1.1 Access via LAN
Access via one of the Ethernet interfaces of your device allows you to to open the Funk-
werk Configuration Interface in a web browser for configuration purposes and to access
your device via Telnet or SSH.
7.1.1.1 HTTP/HTTPS
With a current web browser, you can use the HTML interfaces to configure your device.
The configuration can be set up using the Funkwerk Configuration Interface . To do this,
enter the IP address of your device in the address field of your Web browser.
With DHCP server:
• the IP address that your DHCP server assigned to your device
Without DHCP server:
• With direct connection to the configuration PC: the fallback IP address 192.168.0.252
• The fixed IP address assigned via the ComPoint Manager
Press the Enter (Return) key.
7.1.1.2 Telnet
Apart from configuration using a web browser, with a Telnet connection you can also ac-
cess the SNMP shell and use other configuration options. These are described in Configur-
ation options on page 59.
Funkwerk Enterprise Communications GmbH
7 Access and configuration
bintec W1002/W1002n/W2002/WIx040/WIx065 53
To Next Page
Loading...
Need help?
General
