configuration (see Configuring a PC on page 17).
(c) Assigning a fixed IP address
You can use the ComPoint Manager to assign the required IP address to your device.
Note
Please note:
If your device has obtained an IP address dynamically from a DHCP server operated
in your network for the basic configuration, the fallback IP address 192.168.0.252 is
deleted automatically and your device will no longer function over this address.
However, if you have set up a connection to the device over the fallback IP address
192.168.0.252 or have assigned an IP address with the ComPoint Manager in the ba-
sic configuration, you will only be able to access your device over this IP address. The
device will no longer obtain an IP configuration dynamically over DHCP.
Use the following access data to configure your device in ex works state:
• User Name: admin
• Password: funkwerk
Note
All bintec devices are delivered with the same username and password. As long as
the password remains unchanged, they are therefore not protected against unauthor-
ized use. Make sure you change the passwords to prevent unauthorized access to
your device! (see Modify system password on page 20).
4.1.2 Software update
Your device contains the version of the system software available at the time of production.
More recent versions may have since been released. You can easily perform an update
with the Funkwerk Configuration Interface using the Maintenance->Software & Config-
uration menu. For a description of the procedure, see Software Update on page 23.
4.2 System requirements
For configuration, your PC must meet the following system requirements:
4 Basic configuration Funkwerk Enterprise Communications GmbH
14 bintec W1002/W1002n/W2002/WIx040/WIx065
To Next Page
Loading...
Need help?
General
