Funkwerk W1002 - SNMP Trap Options

Every SNMP management system contains an MIB. SNMP can be used to configure, con-
trol and administrate various network components from one system. Such an SNMP tool is
included on your device: the Configuration Manager. As SNMP is a standard protocol, you
can use any other SNMP managers, e.g. HPOpenView.
For more information on the SNMP versions, see the relevant RFCs and drafts:
• SNMP V. 1: RFC 1157
• SNMP V. 2c: RFC 1901 – 1908
• SNMP V. 3: RFC 3410 – 3418
18.4.1 SNMP Trap Options
In the event of errors, a message - known as a trap packet - is sent unrequested to monitor
the system.
In the External Reporting -> SNMP -> SNMP Trap Options menu, you can configure the
sending of traps.
Fig. 157: External Reporting->SNMP->SNMP Trap Options
The External Reporting -> SNMP -> SNMP Trap Options menu consists of the following
fields:
Fields in the SNMP Trap Options Basic Parameters menu
Field Description
SNMP Trap Broadcast- Select whether the transfer of SNMP traps is to be activated.
18 External Reporting Funkwerk Enterprise Communications GmbH
348 bintec W1002/W1002n/W2002/WIx040/WIx065