External Reporting
Menu Function
Syslog In this menu, you configure the host to which the data logged in-
ternally on the device is forwarded for saving and further pro-
cessing.
IP Accounting In this menu, you decide for which interfaces accounting mes-
sages are to be generated.
E-mail alert Depending on the configuration, in this menu e-mails are sent to
the administrator as soon as relevant syslog messages occur.
SNMP In this menu, you configure whether the device is to listen for
external SNMP accesses and send SNMP traps.
Activity Monitor In this menu, you configure the surveillance of your device with
the Windows Tool Activity Monitor (component of BRICKware
for Windows).
Monitoring menus
Menu Function
Internal Log In this menu, the system messages are displayed.
IPSec In this menu, the IPSec connections and connection statistics
that are currently active are displayed.
Interfaces In this menu, connection statistics and status of all interfaces
are displayed.
WLAN This menu shows you the WLAN connections statistics.
Bridges In this menu you can view the current values of the configured
bridges.
7.3.2 The Setup Tool for experts
The Setup Tool is a menu-controlled ASCII tool for the configuration and administration of
your device and, in addition to the SNMP commands, also allows access to all the configur-
ation parameters.
To start the Setup Tool, you can be connected to the device in any way you like: It does not
matter whether you connect to the device via the LAN or via a serial connection.
Funkwerk Enterprise Communications GmbH
7 Access and configuration
bintec W1002/W1002n/W2002/WIx040/WIx065 73
To Next Page
Loading...
Need help?
General
