Funkwerk W1002 User Manual

Field Description
• Never dialup: The route can be used if the interface is
"up".
• Always dialup: The route can be used if the interface is
"up". If the interface is "dormant", then dial and wait until the
interface is "up". In this case, an alternative interface with a
poorer metric is used for routing until the interface is "up".
12.1.2 Options
Back Route Verify
The term Back Route Verify describes a very simple but powerful function. If a check is ac-
tivated for an interface, incoming data packets are only accepted over this interface if out-
going response packets are routed over the same interface. You can therefore prevent the
acceptance of packets with false IP addresses - even without using filters.
Fig. 81: Routing -> Routes -> Options
The Routing -> Routes -> Options menu consists of the following fields:
Fields in the OptionsBack Route Verify menu
Field Description
Mode Select how the interfaces to be activated for Back Route Verify
are to be specified.
12 Routing Funkwerk Enterprise Communications GmbH
182 bintec W1002/W1002n/W2002/WIx040/WIx065

Funkwerk W1002 Specifications

General

Brand	Funkwerk
Model	W1002
Category	Wireless Access Point
Language	English