EasyManuals Logo

Funkwerk W1002 User Manual

Funkwerk W1002
437 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
any information on the device or change the configuration without authentication.
7.2.1 User names and passwords in ex works state
In its ex works state, your device is provided with the following user names and passwords:
User names and passwords in ex works state
User name Password Authorisations
admin funkwerk Read and change system variables, store configurations; use
Funkwerk Configuration Interface and Setup Tool.
write public Read and write system variables (except passwords) (changes
are lost when you switch off your device).
read public Read system variables (except passwords).
It is only possible to change and save configurations if you log in with the user name ad-
min. Access information (user names and passwords) can also only be changed if you log
in with the user name admin. For security reasons, passwords are normally shown on the
Setup Tool screen not in plain text, but only as asterisks. The user names, on the other
hand, are displayed as plain text.
The security concept of your device enables you to read all the other configuration settings
with the user name read, but not the access information. It is therefore impossible to log in
with read, read the password of the admin user and subsequently log in with admin and
make changes to the configuration.
Caution
All bintec devices are delivered with the same username and password. As long as
the password remains unchanged, they are therefore not protected against unauthor-
ized use. How to change the passwords is described in Changing the Password on
page 77.
Make sure you change the passwords to prevent unauthorized access to your device!
If you have forgotten your password, you must reset your device to the ex works state,
which means your configuration will be lost.
7.2.2 Logging in for Configuration
Set up a connection to the device. The access options are described in Access Options on
page 53.
7 Access and configuration Funkwerk Enterprise Communications GmbH
58 bintec W1002/W1002n/W2002/WIx040/WIx065

Table of Contents

Other manuals for Funkwerk W1002

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Funkwerk W1002 and is the answer not in the manual?

Funkwerk W1002 Specifications

General IconGeneral
BrandFunkwerk
ModelW1002
CategoryWireless Access Point
LanguageEnglish

Related product manuals