(2) If necessary, enter more characters to refine the search.
(3) The Backspace or Delete key can be used to edit the search string.
The cursor automatically jumps to the first match it finds with the corresponding initial let-
ters. The characters entered for the search are displayed in the help line at the bottom of
the menu.
Do not enter invisible characters, such as Tabulator or Space as they stop the search and
could cause a function to be executed.
Note
Make sure the cursor is positioned in a list element. The search cannot run if the curs-
or is located in a command field, e.g. ADD or DELETE.
In the menu shown above, the entries provide the following search results:
Search results
Input Cursor jumps to entry
v or V Visitors
bi , Bi , bI , BI BigBoss
Department Department1, on entering 2 to Department2
7.3.2.4 Changing the Password
The procedure described below for changing the password applies to all passwords on
your device: the access passwords for the user names admin, read and write, the HTTP
password, the PPP password and the provider password.
Any character may be used for entering a password. Passwords are only displayed as as-
terisks, even while changes are being made. The number of asterisks is the same as the
number of characters in the password.
Note
To start the Setup Tool of your device in a mode in which the passwords are displayed
in plain text and can be changed by one-time editing, you must enter the command
setup -p. This option only exists if you have logged in on your device with the user
name admin. In the password field, the Backspace key always deletes the complete
entry, not just one character.
Proceed as follows:
Funkwerk Enterprise Communications GmbH
7 Access and configuration
bintec W1002/W1002n/W2002/WIx040/WIx065 77
To Next Page
Loading...
Need help?
General
