Funkwerk W1002 User Manual

Field Description
ing Your device then sends SNMP traps to the LAN's broadcast ad-
dress.
The function is activated by choosing Enabled.
The function is disabled by default.
SNMP Trap UDP Port Only if SNMP Trap Broadcasting is enabled.
Enter the number of the UDP port to which your device is to
send SNMP traps.
Any whole number is possible.
The default value is 162.
SNMP Trap Community Only if SNMP Trap Broadcasting is enabled.
Enter a new SNMP code. This must be sent by the SNMP Man-
ager with every SNMP request so that this is accepted by your
device.
A character string of between 0 and 255 characters is possible
here.
The default value is SNMP Trap.
18.4.2 SNMP Trap Hosts
In this menu, you specify the IP addresses to which your device is to send the SNMP traps.
In the External Reporting -> SNMP -> SNMP Trap Hosts menu, a list of all configured
SNMP trap hosts is shown.
18.4.2.1 New
Choose the New button to set up new SNMP trap hosts.
Funkwerk Enterprise Communications GmbH
18 External Reporting
bintec W1002/W1002n/W2002/WIx040/WIx065 349

Funkwerk W1002 Specifications

General

Brand	Funkwerk
Model	W1002
Category	Wireless Access Point
Language	English