Field Description
The default value is 10.0.0.140.
Remote PPTP IP Ad-
dress
Enter the IP address of the PPTP partner.
The default value is 10.0.0.138.
LCP Alive Check Check whether the availability of the remote terminal is to be
checked by sending LCP echo requests or replies. This makes
it possible to switch to a backup connection more quickly in the
event of line faults.
The function is activated with Enabled.
The function is disabled by default.
13.2 Real Time Jitter Control
When telephoning over the Internet, voice data packets normally have the highest priority.
Nevertheless, if the upstream bandwidth is low, noticeable delays in voice transmission can
occur when other packets are routed at the same time.
The real time jitter control function solves this problem. So that the "line" is not blocked for
too long for the voice data packets, the size of the other packets can be reduced, if re-
quired, during a telephone call.
13.2.1 Controlled interfaces
In the WAN->Real Time Jitter Control->Controlled Interfaces menu, a list of all inter-
faces is shown for which the real time jitter control has been configured.
13.2.1.1 New
Click o the New button to set up portforwarding for other interfaces.
13 WAN Funkwerk Enterprise Communications GmbH
220 bintec W1002/W1002n/W2002/WIx040/WIx065
To Next Page
Loading...
