File types 6 Data Recorder
DMS Go+ Edition 4 (05/2014) 6-5
File type CUSTOM LINEAR
This file type has two structural elements (measurement
location and measuring point) Measurement locations
must be identified by specific names, measuring points
are consecutively numbered. The required number of
measuring points can be assigned to each measure
-
ment location. The number of measuring points is deter-
mined during file creation.
Typical application: Measurements on pipelines.
File type CUSTOM POINT
This file type has two structural elements (measurement
location and measuring point) Measurement locations
and measuring points must be identified by specific
names, and the required number of measuring points
can be assigned to each measurement location. The
number of measuring points is determined during file
creation.
Typical application: Measurements on pipe systems,
pressure vessels.
To Next Page
Loading...
