GE DMS Go+ - Calibration Reminder

5 Operation Other functions
5-50 Edition 4 (05/2014) DMS Go+
Calibration reminder
Certain measurement tasks require a regular calibration
of the gauge.
The reminder function of the DMS Go+ uses three crite-
ria from which you can choose one:
● Time in minutes
● Number of readings
● Power On and Off
If you switch on the reminder functions of DMS Go+, a
reminder icon is displayed at the top left corner of the
display screen once the selected criterion is reached
(
see Section Status display icons, page 0-5).
– In the function group PROBE&CAL, select the func-
tion CAL REMINDER.
– Press one of the left or right arrow keys. A selection
menu is displayed.
– Press one of the left or right arrow keys in order to
select the required criterion.
– If necessary, press one of the up or down arrow keys
in order to define additional settings for the selected
criterion.
– Press one of the left or right arrow keys in order to
set the additional data.
– Finally, press the function key 2 (function CONFIRM)
in order to save the data. The selection menu disap
-
pears, and the selected settings are displayed at the
function CAL REMINDER.