Default settings 5 Operation
DMS Go+ Edition 4 (05/2014) 5-3
Units setting
You can use the function UNIT (function group CON-
FIG) to select the required units (mm or in). You can
change the units any time. All values are adjusted ac
-
cordingly.
– In the function group CONFIG, select the function
UNIT.
– Choose the required unit. The unit changes immedi-
ately.
Resolution setting
You can use the function RESOLUTION (function group
CONFIG) to select the resolution for the display of read
-
ings. If the setting AUTO is selected, the readings up to
100
mm are displayed with two decimal places (up to
10
in with three decimal places).
– In the function group CONFIG, select the function
RESOLUTION.
– Choose the required resolution. The display of read-
ings changes immediately.
To Next Page
Loading...
