Editing files 6 Data Recorder
DMS Go+ Edition 4 (05/2014) 6-33
Automatic advance
After saving a reading using the function SEND, the next
data point is usually selected automatically in order to
save the following reading to that position.
You can switch off this automatic data point selection or
define other details for it.
These settings only apply to the currently
loaded file in each case.
By configuring this function, you can adjust the order for
saving measurement results to the corresponding test
task. In this way, you can e.g. determine whether you
wish to proceed by rows or by columns for saving mea
-
surement results to a grid (file type GRID).
To Next Page
Loading...
