GE DMS Go+ - B-Scan

1 Introduction Wall thickness measurement using the DMS Go+
1-20 Edition 4 (05/2014) DMS Go+
B-scan
The B-scan is a special, path-dependent representation
of the test object's wall thickness. This representation is
ideal for the display of corroded sections. The probe is
guided over the section to be tested of the component
for this representation.
The cross section of the test object shown in the display
of DMS Go+ gives the operator a quick overview of the
thickness distribution on the component. In this regard,
the minimum wall thicknesses become especially well
visible. The following display shows a typical
B-scan in the display of DMS Go+.