5 Operation Default settings
5-4 Edition 4 (05/2014) DMS Go+
Radix
You can choose the radix symbol. All data are displayed
and saved using the selected radix.
– In the function group CONFIG, select the function
RADIX.
– Choose the required radix. The display of readings
changes immediately.
Last reading
You can choose the display mode for the thickness val-
ue measured last – after uncoupling and before cou-
pling the next time.
– In the function group CONFIG, select the function
LAST READING.
– Choose the required display mode. The display of
readings changes immediately.
To Next Page
Loading...
