3 Initial start-up Starting the DMS Go+
3-12 Edition 4 (05/2014) DMS Go+
Powering Off
To power the DMS Go+ off, shortly press the Power key
on the side of the instrument casing.
The settings of all function values and the default set-
tings (language and units) are retained after powering
off.
Factory default setting (Reset)
If you can no longer use the functions of your instrument
or if the instrument no longer reacts as expected, you
can reset it to the factory default settings. Any data
saved to the SD card will be retained, all other individual
settings, e.g. language and units, will be reset to the fac
-
tory default settings.
– Power the instrument off.
– Press the further ends of the two Function keys (1
and 2), and the Power key
(3) simultaneously, and
hold all three keys pressed until the start display or
the page of the instrument selection appears.
The instrument starts with the factory default settings
(for language selection,
see Section Language setting,
page 5-2).
1
3
2
To Next Page
Loading...
Need help?
General
