Default settings 5 Operation
DMS Go+ Edition 4 (05/2014) 5-13
Configuring data boxes
You can use the function RESULTS to choose the data
to be displayed in the six data boxes at the top of the
screen display (
see Section Icons and information,
page 4-5).
You have a choice between the following data:
● OFF (no display)
● P-DLY (probe delay)
● LOC (measuring location)
● M-GAIN (maximum gain setting)
● TEMP (material temperature setting)
● GAIN (current gain)
● T-THK (temperature-compensated wall thickness)
● THK (measured wall thickness)
● C-THK (coating thickness in the operating mode
TopCOAT)
To Next Page
Loading...
