GE DMS Go+ - Adding Comments

6 Data Recorder Saving measurement results
6-20 Edition 4 (05/2014) DMS Go+
Adding comments
If necessary, you can add one or several comments to
each reading. To do this, choose the required com
-
ments from a ready-made list of comments.
Each file has a separate comment list automatically
generated on the basis of the master comment list (
see
Section Master comment list, page 6-8).
– Select a measuring point which has a reading saved
to it (
see Section Selecting individual measuring
points, page 6-16).
– Press the center key of the keypad long. The func-
tions of the function keys change.
– Press the function key 3 (function NOTE). A selection
menu is displayed.
– Press one of the up or down arrow keys in order to
mark a comment.
– Press the function key 2 (function TAG) in order to
select the marked comment. Selected comments are
marked with a cross before the code letter.
– If necessary, choose other comments in the same
way.
– If a selected comment is marked, press the function
key 2 (function UN-TAG) in order to cancel the selec
-
tion.