6 Data Recorder Working with files
6-12 Edition 4 (05/2014) DMS Go+
– Press one of the up or down arrow keys in order to
mark the basic parameters available in the selected
file type.
– Press the left or right arrow keys in order to select or
set the values of the individual parameters.
– Press the function key 4 (function NEXT) in order to
enter the file name.
– Press the arrow keys to mark the first character.
– Press the center key of the keypad to select the
marked character.
– Choose other characters in the same way.
– Press the function key 3 (function BKSP) in order to
delete the last character.
– Press the function key 4 (function NEXT) in order to
switch to the next area of file definition.
– Press one of the up or down arrow keys in order to
select the individual parameters.
– Select the individual parameters and set the required
values.
– If the selected file type allows it, press the function
key
4 (function NEXT) in order to switch to the next
area of file definition.
– Finally, press the function key 2 (function DONE) in
order to save the new file.
The file is saved and is available for recording readings.
You can already enter the values for the
functions T-MIN and T-MAX at this point.
These settings will subsequently apply when
the file is loaded (
see Section Configuring
alarm functions, page 5-39).
To Next Page
Loading...
