GE DMS Go+ - Page 169

Evaluations 6 Data Recorder
DMS Go+ Edition 4 (05/2014) 6-37
– Load a Data Recorder file (see Section Loading a
file, page 6-14).
– In the function group DR, select the function PROP-
ERTIES.
– Press one of the left or right arrow keys. The file
properties are displayed.
– Press the left or right arrow key in order to select the
group STATS.
– Press either the up or down arrow key in order to
view the statistical data.
Searching for certain data
You can search the statistics for certain data. Only the
data of one or several statistical parameters are then
displayed, e.g. all data points without a reading.
– Press either the up or down arrow key in order to
mark a parameter of the statistics.
– Press the function key 2 (function TAG) in order to
select the marked parameter.
– If necessary, choose other parameters in the same
way.
– Press the function key 3 (function SEARCH) in order
to start the search for the corresponding data. The
corresponding data points are displayed above the
statistics.
– Press the function key 3 (function STOP) in order to
end the search.