8 Maintenance and care Software updates
8-6 Edition 4 (05/2014) DMS Go+
– Press the function key 2 (1), the function key 4 (2),
and the Power key
(3) at the same time, and hold all
three keys pressed until the display screen is turned
on and the message FLASH UPGRADE MODE ap
-
pears.
The installation process will then start. The following
messages are displayed one by one:
LOADING FILE
VERIFYING FILE
PROGRAMMING FLASH
At the end of the installation, the instrument is powered
off automatically. After this, you can power the DMS
Go+ on again and use the new software version.
For resetting the instrument to factory default
settings,
see Section Factory default set-
ting (Reset), page 3-12.
1
3
2
To Next Page
Loading...
