10 Appendix Function directory
10-22 Edition 4 (05/2014) DMS Go+
VEL REF. BLOCK CONFIG Calibration block data for the operating modes TopCOAT and
AUTO-V.
5-48
CALIBRATION PROBE&CAL Start of calibration to the sound velocity. 5-27
Master Cmt DR Editing the master comment list. 6-8
LOAD P-SET PARAM Loading of instrument settings from a file on the memory card. 5-19
LAST READING CONFIG Display of the thickness value that was measured last. 5-4
MAX ALARM Alarm function for exceeding a maximum value. 5-39
MAX ALARM ALARM Wall thickness value which triggers an alarm if exceeded. 5-39
MAX GAIN MODE MEASURE Choice of amplification method. 5-34
MAX GAIN MEASURE Setting of gain values for the selected amplification method. 5-34
MENU MODE CONFIG Disabling the access to the instrument setup function. 5-8
TG MODE PROBE&CAL Choice of the suitable measurement mode for the probe type. 5-22
MIN ALARM Alarm function for falling below a minimum value. 5-39
MIN ALARM ALARM Wall thickness value which triggers an alarm if fallen below. 5-39
MODE MEASURE Choice of the operating mode. 5-17
NOMINAL MEASURE Setting of nominal value for the differential value display. 5-46
ZERO PROBE&CAL Choice of the probe zero offset method. 5-25
ZERO BLOCK CONFIG Data of the reference block for the probe zero offset. 5-48
Function Function group Description see page
To Next Page
Loading...
