Power supply 3 Initial start-up
DMS Go+ Edition 4 (05/2014) 3-3
Connecting the instrument
Connect the DMS Go+ to the mains socket-outlet by
means of the corresponding charger/power adapter.
The socket-contact for connecting the charger/power
adapter is located on the side of the DMS Go+.
– Align the Lemo plug of the charger/power adapter
with the red mark on the socket (1).
– Push the plug into the socket until it locks into place
with a clearly audible click.
– When removing the Lemo plug, pull the metal sleeve
on the plug back first in order to open the lock.
In order to power the instrument off correctly,
press the power On/Off key (2) on the side of
the instrument. If the power supply is inter
-
rupted (removing the battery, disconnecting
the power plug), the operation does not end
correctly.
To Next Page
Loading...
