Power supply 3 Initial start-up
DMS Go+ Edition 4 (05/2014) 3-7
Power level indicator
The DMS Go+ is equipped with a power level indicator
that allows to estimate the remaining operating time of
the instrument. A battery icon with the corresponding
charge level is displayed in the top right corner on top of
the A-scan. The battery icon indicates the remaining op
-
erating time or the battery charge level.
The DMS Go+ is automatically powered off if the opera-
tion is no longer ensured. All settings are retained during
battery exchange and are immediately available again
afterwards.
If the battery charge level is low, it is abso-
lutely necessary that you finish your test job,
power off the instrument, and replace the
battery. You should carry a second battery
along with you if you cannot use mains pow
-
er supply to operate the instrument.
Icon Meaning
Battery charge level,
remaining operating time
in hours (approximate value)
Charger/power adapter is connected,
percentage of battery charge level
(approximate value)
Warning: Low battery charge level,
remaining operating time
in minutes (approximate value)
To Next Page
Loading...
Need help?
General
