Default settings 5 Operation
DMS Go+ Edition 4 (05/2014) 5-11
Changing a password
You can change the password at any time. To do this,
you must first enter the current password.
– In the function group CONFIG, select the function
PASSWORD.
– Press one of the left or right arrow keys.
– Press the arrow keys to mark the first character for
the current password.
– Press the center key of the keypad to select the
marked character.
– Choose other characters in the same way.
– Press the function key 4 (function NEXT).
– Set the new password (see Section Saving a new
password, page 5-10).
Deactivating password protection
To deactivate the password protection, proceed in the
same way as for changing the password. Instead of a
new password, however, you don't choose any charac
-
ters.
– In the function group CONFIG, select the function
PASSWORD.
– Press one of the left or right arrow keys.
– Press the arrow keys to mark the first character for
the current password.
– Press the center key of the keypad to select the
marked character.
– Choose other characters in the same way.
– Press the function key 4 (function NEXT). However,
do not choose any characters at this point.
– Press the function key 4 (function NEXT) and, to
check, the function key
4 one more time (function
NEXT). The password protection is deactivated.
To Next Page
Loading...
