326 MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F
Configure Primary and Secondary routes towards back-office network
5. Configure primary route towards SCADA back-office network (10.10.1.0/24) with NX as the
outgoing interface and with address of R1’s interface on NX backhaul as the next-hop. Also,
configure this route with verify-reachability using NX-LINK-CHECK operation, which checks
the reachability of the back-office network via this route.
- Navigate to Routing ---> Basic Config / IPv4 and click ‘Add’ to add the primary route over
NX:
To Next Page
Loading...
