System ID:
Enter the system ID as a four-digit hexadecimal
number. Use the numeric keypad, the soft keys or
tuning knob to make this entry. If the screen
already displays a system ID and it requires a
change, enter the new system ID over the old.
NOTE
The System ID must match one of the system
IDs in the Radio Configuration screen in
order to decode radio information. Refer to
paragraph 6-8.
Call Type:
Move the cursor to the "Call Type" field and
enter Fleet or Subfleet.
Fleet:, Subfleet:, Unit:
If a radio initiated dispatch test has been executed
prior to the system initiated test, the fleet,
subfleet, and unit ID decoded from the ISW will
be displayed.
6-6.2 RF ZONE
Band:
Band selects the frequency channel plan for the
analyzer. Enter the Frequency Band with
softkeys.
800 MHz (US)
Selection of the 800 MHz (US) band configures
the analyzer for the frequency and channel plan
described in table 6-1. This table shows the
analyzer transmit frequency ranges.
800 MHz (Int'l)
Selection of the 800 MHz (Int'l) band configures
the trunking analyzer for the frequency and chan-
nel plan described in table 6-2. This table shows
the analyzer transmit frequency.
JSMR
Selection of the JSMR band configures the
trunking analyzer for the frequency and channel
plan described in table 6-3. This table shows the
analyzer transmit frequency.
900 MHz
Selection of the 900 MHz band configures the
analyzer for the frequency and channel plan
described in table 6-4. This table shows the
analyzer transmit frequency.
93
To Next Page
Loading...
Need help?
General
