7-3.4 System Initiated Phone Interconnect
Test Sequence, Trunk II
Configure the analyzer for trunk mode (paragraph
6-5) and System Initiated Testing (paragraph 6-7).
NOTE
Fleet, Subfleet, and Unit ID information must
be entered before the execution of a System
Initiated test. If a Radio Initiated test is
executed prior to the System Initiated test,
these fields are automatically updated. If
required, refer to paragraph 6-8.1 for in-
formation related to entry and storage of sys-
tem/fleet map configurations.
NOTE
SMARTZONE configures the analyzer to
perform a SMARTZONE affiliation sequence
prior to executing the dispatch test sequence.
If the radio is not capable of SMARTZONE
auto affiliation, the selection should be set to
DISABLED.
1. Enter the following parameters:
Sig Type: Trunk II
ID Disp: HEX or DEC
Call Seq: PHONE INTERCONNECT
2. Set the System ID to match the radio system
ID and one of the system IDs in the Radio
configuration screen in order to decode radio
ID information.
3. Enter talk group, call type, and unit ID.
NOTE
If an announcement call type is selected, the
operator must also set the talk group to the
announcement talk group monitored by the
radio.
4. Enter the CCTx or Control Channel number.
Enter the VCTx or voice channel number.
NOTE
Splinter channels can only be entered by
frequency. Standard channels can be entered
by frequency or channel number (channel
numbers only map to standard channel
frequencies).
5. Set the monitor attenuation and port selection.
Suggested port selection is RF I/O with 20 dB
attenuation.
6. Set the generator attenuation and port
selection. Suggested port selection is RF I/O
with -50 dB for the level setting.
7. Press the start test softkey.
8. The status thermometer displays the major
signaling events that occur during a system
initiated Phone Interconnect test. Refer to
table 7-15 (Trunk II auto affiliation disabled),
or table 7-16 (Trunk II with auto affiliation).
123
To Next Page
Loading...
Need help?
General
