1
Section 1
INTRODUCTION
1-1 SCOPE OF MANUAL
This manual contains information for using the
R2600 Series Communications System Analyzers.
These Analyzers incorporate many devices and
functions, permitting a technician to completely
monitor and service radio communications
equipment in the shop and in the field.
1-2 SAFETY SUMMARY
The following general safety precautions must be
observed during all phases of operation, service
and repair of this equipment. Failure to comply
with these precautions or warnings violates safety
standards of design, manufacture, and intended
use of the equipment. General Dynamics.
assumes no liability for the customer's failure to
comply with these requirements.
The safety precautions and warnings listed below
represent warnings of certain dangers of which
General Dynamics is aware. You as the user of
the product, should follow these warnings and all
other safety precautions necessary for the safe
operation of the equipment in your operating
environment.
1-2.1 Grounding the Analyzer
To minimize shock hazard, the Analyzer
enclosure must be connected to an electrical
ground. This ground connection is provided via a
three wire AC power cable. The power cable
must be plugged into an approved three-contact
electrical outlet. If the unit is not properly
grounded while operating from an AC power
source, the voltage potential between it and
ground may cause an electrical shock.
1-2.2 Unit is Live When Plugged In
Internal circuits are live when the power cable is
plugged in, although the front panel switch is in
the STANDBY position. The input power plug is
the disconnect device.
1-2.3 Keep Away From Live Circuits
Operating personnel must not remove equipment
covers. Only Factory Authorized Service
Personnel or other qualified maintenance
personnel may remove equipment covers for
internal subassembly or component replacement
or any internal adjustment. Disconnect Analyzer
from all voltage sources before removing covers
for adjustments, maintenance or repairs.
Capacitors inside may still be charged even if the
Analyzer is disconnected from the voltage
source.
To Next Page
Loading...
Need help?
General
