174
procedure was unsuccessful, the key inserter
displays "fail."
If key load procedure was successful, disconnect
the key inserter. Be sure to press the EXT KEY
softkey after loading an external key from the key
inserter to transfer the external key into the
analyzer’s key storage memory. This completes
external key loading. It is all right to exit the SET
UP screen.
13-7.3.3 Erasing External Key
To erase an external key, place cursor in
"Display:" field in the Display Zone and select
SET UP softkey. This will access the SET UP
display screen (figure 13-6).
Move cursor to "Algorithm Sel:" field. Using
softkey, select the algorithm associated with the
external key you want to erase.
Move cursor to "Key Type:" field and select
External Key using softkeys.
Press erase ext key softkey (figure 13-9). The
analyzer will erase the stored external key and
display "key erased" in the message area.
To Next Page
Loading...
Need help?
General
