58
Remote Setup
NOTE
Accesses a display table which allows configura-
tion of the RS-232 and printer interface.
Subsequent presses of the PRT key before
printing is complete will overwrite the printer
buffer.
System Functions
If using the LX-810S/220 (220 volt operation)
serial/parallel printer with the Analyzer, refer to
paragraph 4-5 for a special application note.
Accesses softkeys to select the following:
NVM Clear
This softkey erases the entire RF Preset
memory area and front panel CAL memory.
The Analyzer must be recalibrated after this key
has been pressed.
3-8.4 Special Functions Menu
The Special Function mode (figure 3-23) ac-
cessed by pressing the SPF key, provides control
over various system conditions as follows:
NVM Reset
Version
This softkey provides a less extensive system
reset than NVM Clear. CAL and preset memory
are not erased.
Accesses a display table which provides the
internal software version and checksum for the
system and any options present.
Save State
Sets the current condition and settings of the
unit as the power up state.
Figure 3-23. Special Functions Menu
To Next Page
Loading...
Need help?
General
