Chapter 7: Stream Configuration Menu Stream Filtering Configuration
© Harmonic Inc. Manual p/n 101543/Ver 1.0 7-10 ProView 2900 Series/SW Version 1.94
7.5. Stream Filtering Configuration
Stream Filtering is a licensing-required feature that allows the user to define a method for
Service and PID filtering on streams delivered at the ProView 2900 ASI and IP output ports.
The following describes the filtering procedures, using both front panel and web-based
management interfaces:
7.5.1. Filtering Using the Front Panel Interface
To use filtering mode through the front panel perform the following:
1. Configure ASI and/or IP outputs to filtering mode (see section 7.3). To access the
After Filtering submenus go to:
Configuration
Stream
Output
ASI Output Source
After Filtering or
Configuration
Stream
Output
IP Output Source
After Filtering
2. Access the filtering menu by the following path:
Root
Configuration
Stream
Filtering
Filtering
Filtering Filtering
Filtering
1
11
1-
--
-2
22
2-
--
-2
22
2-
--
-4
44
4
1
11
1 General
General General
General
2
22
2 Service
Service Service
Service
3
33
3 PID
PID PID
PID
3. Set the following General sub menu parameters: strategy, mode, Bit-rate mode
and bit-rate. (see section 7.5.3). To access the General submenus go to:
Configuration
Stream
Filtering
General
4. In case that the service filtering strategy is selected, set the required services
(see section 7.5.4). To access the Service submenus go to:
Configuration
Stream
Filtering
Service
5. In case the PID filtering strategy is selected, set the required PIDs (see section
7.5.5). To access the General submenus go to:
Configuration
Stream
Filtering
PID
To Next Page
Loading...
