Harmonic ProView 2900 - 12.3. V Control

Chapter 12: GenLock Configuration Menu SCH Control
© Harmonic Inc. Manual p/n 101543/Ver 1.0 12-3 ProView 2900 Series/SW Version 1.94
12.3. V Control
This submenu allows setting the Vertical GenLock Line. To access the V Control submenu go
to: Root 

 Configuration 

 Genlock 

 V Control
The following figure shows the front panel V Control edit screen:
V Control
V ControlV Control
V Control
+00
+00+00
+00 [
[ [
[Line
LineLine
Line]
]]
]
<
<<
<-
--
-7
7 7
7 -
--
-+06
+06+06
+06>
>>
>
The Vertical Control delay ranges from -7[Line] to +6[Line].
12.4. SCH Control
This submenu allows setting the GenLock phase. To access the SCH Control submenu go to:
Root 

 Configuration 

 Genlock 

 SCH Control
The following figure shows the front panel SCH Control edit screen:
SCH Control
SCH ControlSCH Control
SCH Control
+000
+000+000
+000[
[[
[Degree
DegreeDegree
Degree]
]]
]
<
<<
<0
0 0
0 -
--
-+360
+360+360
+360>
>>
>
The Vertical Control delay ranges from 0 to 360 degrees.