Appendix B: IP Front-End SW Update
© Harmonic Inc. Manual p/n 101543/Ver 1.0 B-2 ProView 2900 Series/SW Version 1.94
15. After a few seconds, power on the ProView 2900.
16. On the ProView 2900 front panel, go to Configuration
Stream
Source and
select FRONT END (IP)
17. Verify the correct upgrading of the new SW version by going in the ProView 2900
front panel to Status
Receiver
General and checking the SW Version
dd/mm/yy mj.mn parameter value
NOTE
If power failure occurs during upgrade, repeat the upgrade from step 1
To Next Page
Loading...
