Hioki 3174 - Page 147

9.3 Communication Methods
141
99
Common Commands (GP-IB only)
Specific Commands (GP-IB only)
Specific Commands (RS-232C only)
Command Explanation
Ref
page
∗ESE
Sets the standard event status enable register. 142
∗
ESE?
Queries the standard event status enable register. 142
∗SRE
Sets the service request enable register. 146
∗
SRE?
Queries the service request enable register. 146
∗STB?
Queries the status byte register. 146
∗
WAI
Waits until all execution is fully completed. 147
Command Explanation
Ref
page
:ESE0
Sets event status enable register 0. 148
:ESE0?
Queries event status enable register 0. 148
:TRANsmit:TERMinator
Sets the data terminator for response messages. 180
:TRANsmit:TERMinator?
Queries the data terminator for response messages. 180
Command Explanation
Ref
page
:SYStem:ERRor?
Queries RS-232C communication errors. 149