Hioki 3174 - Page 146

9.3 Communication Methods
140
:CONFigure:INSulation:RLOWer
Sets the lower-limit test value for insulation-resistance
tests.
167
:CONFigure:INSulation:RLOWer?
Queries the lower-limit test value for insulation-resis-
tance tests.
167
:CONFigure:INSulation:TIMer
Sets the test time for insulation-resistance tests. 167
:CONFigure:INSulation:TIMer?
Queries the test time for insulation-resistance tests. 167
:CONFigure:INSulation:DELay
Sets the delay time for insulation-resistance tests. 168
:CONFigure:INSulation:DELay?
Queries the delay time for insulation-resistance tests. 168
:INSulation:RUPPer
Enables and disables the upper-limit test value for insu-
lation-resistance tests.
168
:INSulation:RUPPer?
Queries the upper-limit test value enablement for insula-
tion-resistance tests.
168
:INSulation:TIMer
Enables and disables the test time for insulation-resis-
tance tests.
169
:INSulation:TIMer?
Queries the test time enablement for insulation-resis-
tance tests.
169
:INSulation:DELay
Sets the delay time ON/OFF for insulation-resistance
tests.
169
:INSulation:DELay?
Queries the delay time ON/OFF for insulation-resis-
tance tests.
169
:INSulation:CNHI
Sets the contact check upper-limit voltage ON/OFF for
insulation-resistance tests.
170
:INSulation:CNHI?
Queries the contact check upper-limit voltage ON/OFF
for insulation-resistance tests.
170
:INSulation:CNLO
Sets the contact check lower-limit voltage ON/OFF for
insulation-resistance tests.
170
:INSulation:CNLO?
Queries the contact check lower-limit voltage ON/OFF
for insulation-resistance tests.
170
:MEASure:RESult:INSulation?
Queries the insulation-resistance test result. 171
:MEASure:INSulation:VOLTage?
Queries the measured voltage value for insulation-resis-
tance tests.
171
:MEASure:INSulation:RESis-
tance?
Queries the measured resistance value for insulation-
resistance tests.
172
:MEASure:INSulation:TIMer?
Queries the test time elapsed for insulation-resistance
tests.
172
:MEMory:INSulation:FILE?
Queries the content of data saved for insulation-resis-
tance tests.
173
:MEMory:INSulation:LOAD
Loads data saved for insulation-resistance tests. 174
:MEMory:INSulation:SAVE
Saves data for insulation-resistance tests to memory
files.
174
:MEMory:INSulation:CLEar
Clears the insulation-resistance test data saved to
memory files.
174
:SYStem:OPTion:P1
Sets the optional functions 1 175
:SYStem:OPTion:P1?
Queries the optional functions 1 176
:SYStem:OPTion:P2
Sets the optional functions 2 177
:SYStem:OPTion:P2?
Queries the optional functions 2 178
:SYStem:STATus
Set status out 179
:SYStem:STATus?
Query status out 179
:SYStem:LOCAl
Cancel remote 180
:SYStem:RESet
Initialize to the default factory settings 180
Command Explanation
Ref
page