Wireless LAN – WLAN
118
3.9
Bandwidth limits in the WLAN
BAT54-Rail/F..
Release
7.54
06/08
Note: The significance of the Rx and Tx values depends on the device's op-
erating mode. In this case, as an access point, Rx stands for "Send data"
and Tx stands for "Receive data".
Configuration with LANconfig
The maximum bandwidths for the connected clients are entered in LANconfig
in the MAC access list in the 'WLAN Security' configuration area on the 'Sta-
tions' tab page.
Configuration with WEBconfig, Telnet or SSH
Under WEBconfig, Telnet or SSH client you will find the MAC access list un-
der the following paths:
3.9.2 Operating as a Client
If the device is operated as a WLAN client, the device can transmit its maxi-
mum bandwidth when it registers with the access point. The access point
then provides the actual maximum bandwidths with proprietary limits for this
client where necessary.
Note: The significance of the Rx and Tx values depends on the device's op-
erating mode. In this case, as a client, Tx stands for "Send data" and Rx
stands for "Receive data".
Configuration tool Menu/Table
WEBconfig Expert configuration
 Setup  WLAN  Access list
Terminal/Telnet
Setup/WLAN/Access List
To Next Page
Loading...
Need help?
General
