Wireless LAN – WLAN
BAT54-Rail/F..
Release
7.54
06/08
3.6
Client mode
95
Note: A WLAN interface can only be set to one of the two operating modes.
Simultaneous operation of a WLAN interface as both access point and cli-
ent is not supported.
Many models can not be operated as an access point. In this case the
WLAN operating mode is permanently set to 'Client'.
Under WEBconfig or Telnet the setting for the operating mode of the physical
WLAN interface can be found under the following paths:
U Client settings
For BAT Wireless Routers in client mode, further settings/client behavior can
be configured from the 'Client mode' tab under the settings for the physical
interfaces.
V To edit the settings for client mode in LANconfig, go to the 'Client mode'
tab under the physical WLAN settings for the desired WLAN interface.
V In 'Scan bands', define whether the client station scans just the 2.4 GHz,
just the 5 GHz, or all of the available bands to locate an access point.
Configuration tool Menu/Table
WEBconfig Expert configuration
Setup Interfaces WLAN Operational settings
Terminal/Telnet
Setup/Interfaces/WLAN/
Operational settings
To Next Page
Loading...
