Hirschmann BAT54-Rail - Configuring the Spanning Tree Protocol

Routing and WAN connections
458
11.17 The rapid spanning tree protocol
BAT54-Rail/F..
Release 7.54 06/08
11.17.3Configuring the Spanning Tree Protocol
The following parameters are available for configuring RSTP or STP func-
tionality in BAT:
U General parameters
D Spanning tree operating
When Spanning Tree is turned off, a BAT does not send any Spanning
Tree packets and passes received packets along instead of processing
them itself.
D Protocol version
D Classic: Uses the classical STP to determine network topology.
D Rapid: Uses the RSTP method to determine network topology.
Configuration tool Call
LANconfig Interfaces
 Span. Tree
WEBconfig, Telnet Expert Configuration > Setup > LAN Bridge > Spanning Tree