Security
240
7.1
Protection for the configuration
BAT54-Rail/F..
Release
7.54
06/08
D Lock configuration for (
Lock-minutes
)
7.1.3 Restriction of the access rights on the
configuration
Access to the internal functions of the devices can be restricted separately
for each access method as follows:
D ISDN administrative account
D LAN
D Wireless LAN (WLAN)
D WAN e.g. ISDN, DSL or ADSL)
For network-based configuration access further restrictions can be made,
e.g. that solely specified IP addresses or dedicated LANCAPI clients are al-
lowed to do so. Additionally, all following internal functions are separately se-
lectable.
D LANconfig (TFTP)
D WEBconfig (HTTP, HTTPS)
D SNMP
D Terminal/Telnet
Note: The use of the internal functions with a WAN interface of devices with
VPN can be restricted merely for the VPN connection.
U Restrictions on the ISDN administrative account
As long as no MSN-configuration is entered a non-configured BAT accepts
the calls on all MSNs. As soon as the first change in the configuration ist
saved the device only accepts calls on the configuration MSN.
Note: If no configuration MSN ist entered when configuring the first time, the
remote configuration ist switched off and the device ist protected from the
access over the ISDN line.
V Change to the register card 'Admin' in the 'Management' configuration ar-
ea:
Configuration tool Run
LANconfig Management
Admin
WEBconfig Expert Configuration
Setup Config
Terminal/Telnet
Setup/Config
To Next Page
Loading...
