Configuration and management
148
4.7
How to reset the device?
BAT54-Rail/F..
Release
7.54
06/08
V The device now expects a firmware upload. To initiate this, in Hypertermi-
nal you click on Transfer
 Send file and select X-Modem as the transfer
protocol.
Note: Uploading the firmware in this way completely deletes the configura-
tion, which is returned to its ex-factory settings! Consequently, this option
should only be used if the configuration password is no longer available.
4.7 How to reset the device?
If you have to configure the device regardless of possible existing settings,
or if a connection to the device configuration failed, you can put back the de-
vice into the factory default state with a Reset. To do so, push the Reset but-
ton until the device LEDs will light up (approx. 5 seconds).
Note: After applying the reset, the device will start fresh with factory defaults.
All settings will be lost. Therefore, you should save the current configura-
tion if possible before the reset!
WAN ISDN COM
TH4 ETH3 ETH2 ETH1
Reset
Config(COM)
Antenna Main
Reset switch (according to the model type on the
front or rear panel)
To Next Page
Loading...
Need help?
General
