Wireless LAN – WLAN
BAT54-Rail/F..
Release
7.54
06/08
3.4
Configuration of WLAN parameters
71
D Point-to-point 'Off': The access point only communicates with mobile cli-
ents
D Point-to-point 'On': The access point can communicate with other access
points and with mobile clients
D Point-to-point 'Exclusive': The access point only communicates with other
access points
The input fields are for the MAC addresses of the WLAN cards for the point-
to-point connections (up to 7).
Note: Please observe that only the MAC addresses of the WLAN cards at the
other end of the connections are to be entered here! Not the access
point's own MAC address, and not the MAC addresses from any other in-
terfaces that may be present in the access points.
Configuration with WEBconfig or Telnet
Under WEBconfig or Telnet you can set the settings for the point-to-point
connections under the following paths:
U Client mode
If the BAT Wireless Router device is operating as a client, the tab 'Client
mode' can be used for further settings that affect the behavior as a client.
Configuration tool Menu/Table
WEBconfig Expert configuration
Setup Interfaces WLAN-Interfaces Interpoint-
Settings
Terminal/Telnet
cd /Setup/Interfaces/WLAN-Interfaces/
Interpoint-Settings
To Next Page
Loading...
