Hirschmann BAT54-Rail - Loopback Addresses for SYSLOG Clients

Configuration and management
162
4.9 Named loopback addresses
BAT54-Rail/F..
Release 7.54 06/08
D Name or address
Name or IP address of the NTP server. The BAT Router attempts to reach
the servers in the order that they are entered.
D Maximum 5 entries.
D Loopback address
Sender address sent with the NTP request; this is also the destination for
the NTP answer. The following can be entered as the loopback address:
D Name of a defined IP network.
D 'INT' for the IP address in the first network with the setting 'Intranet'.
D 'DMZ' for the IP address in the first network with the setting 'DMZ'.
Note: If the list of IP networks or loopback addresses contains an entry
named 'DMZ' then the associated IP address will be used.
D Name of a loopback address.
D Any other IP address.
4.9.3 Loopback addresses for SYSLOG clients
The SYSLOG module enables the logging of accesses to the BAT Router.
SYSLOG clients are set up to be able to receive the SYSLOG messages.
Configuration tool Menu/Table
LANconfig Date & time
 Synchronization  Time server
WEBconfig, Telnet Expert configuration > Setup > NTP > RQ address